Reply #23: Going over to home depot to pick up some materials for up coming project Monday

[Wash. state Desk Jet]

I will take a look at the flooring. Inter locking and traffic master ,it seems to me it should install same as any other traffic master product. There is cutting and fitting involved. A small table saw ,a roto zip is handy and a 12 inch compound miter saw,plus skill saw. Each box comes with installation instructions ,you start where the directions say to start. Cutting and fitting.

The areas where it jogs you say, that most likely is more like cutting and fitting tile,as in a tile in counter top .

Bending it up, the contractor did not know what material you were talking about. You do that with vinyl sheet flooring or counter top laminate ,using a heat gun to heat the laminate to shape the bends and curves.

You should put some pics up of the problem areas you are encountering.
I can get a contractor to contractor consult at home depot on the installation procedures of that particular product line in traffic masters product line, as though I am considering selling it to my clients.

Every home depot store must sell a million dollars inventory a day just to keep the doors open!And so if they can't rob my job by stealing my clients ,than at the very least ,they can sell me on the products!Since they buy in mega bulk ,there prices are hard for other suppliers to beat. but where they get you is on the special orders. The deal prices are limited to what ever products they are pushing at the time.