I knew I should not have started this major project on a Sunday....

[LeftyFingerPop]

Does anyone know the proper torque setting for the tension bolt in a Winslow Sprocket (OEM Model 4500.4.78)? IMPORTANT: The housing for the bolt is the kind that is welded on, rather than held on with the brackets.

Thanks.

[lost-in-nj]

1. yup

it's


.69

you have to be very accurate


lost


:hi:

[madinmaryland]

2. Pffth!!

PEV!!

:rofl:

[LeftyFingerPop]

3. C'mon lost I'm serious here....

I've got an entire 370 pound Gargan sub-assembly spread out on my living room floor. It's Sunday night, I have not even begun the machining of the compression joints yet, and you are making jokes???? :hi:

[darkstar]

4. URGENT WARNING

Don't take this another step further until you have properly gapped the tension idle bar, because once you get the rocker assembly attached, you won't be able to get to the bolts under the restraint housing unless you have a Manley extension. And I thought sure I'd heard that you didn't have a....

Wait. There's the door.

[Gidney N Cloyd]

5. Remember you need to use a 3/4" gangly wrench on a Hobson spigot. nt