With a power drill motor!!!! I got a 24 volt DeWalt cordless hammer drill that I hardly use. Was gonna use the motor for an RC car (the motor turns at 2000 RPMs wouldn't need much gearing to make a fast car). The only problem would be any mixer powered by this motor would need to be bolted to the couter top, in a drill the motor has wrist breaking torque. Should have no problems with bread dough.
Powered by DCForum+ Version 1.1 Copyright 1997-2002 DCScripts.com
Software has been extensively modified by the DU administrators
Important Notices: By participating on this discussion
board, visitors agree to abide by the rules outlined on our Rules
page. Messages posted on the Democratic Underground Discussion Forums are the
opinions of the individuals who post them, and do not necessarily represent
the opinions of Democratic Underground, LLC.
Printer-friendly format
Email this thread to a friend
Bookmark this thread
(1000+ posts)
Send PM |
Profile |
Ignore
