in the bobbin casing. Try to remove bobbin, dust bobbin housing under lift arm out with a Q-Tip, remove all the old thread from bobbin and wind on new thread. You may also want to check the teeth area at the needle plate to make sure there's no thread or lint caught there...can really screw up a bobbin.
Did you do anything to the thread feed pressure knob? If it's too tight or too loose, can also cause bobbin probs.
Powered by DCForum+ Version 1.1 Copyright 1997-2002 DCScripts.com
Software has been extensively modified by the DU administrators
Important Notices: By participating on this discussion
board, visitors agree to abide by the rules outlined on our Rules
page. Messages posted on the Democratic Underground Discussion Forums are the
opinions of the individuals who post them, and do not necessarily represent
the opinions of Democratic Underground, LLC.
Printer-friendly format
Email this thread to a friend
Bookmark this thread
(1000+ posts)
Send PM |
Profile |
Ignore
